How to Refill HP DESKJECT 2620 HP Ink Cartridge 123
In this present time, consistently getting a new Cartridge
for your HP Deskjet 2620 or HP Deskjet 2600 is very expensive. And more especially
for those who uses the printer models for business purposes can comfortably say
it takes away most of there profit after a month’s work.
So today on this post I will be educating you on how to successfully
refill HP Deskjet 2620 or HP Deskjet 2600 Ink Cartridge 123
The refill its very cheap and easy to do saving you some
extra cash after your Ink Cartridge 123 runs low
Note: how to Detect if your Ink Cartridge 123 is low
NOTE: in other
not to spoil or damage your Ink Cartridge 123 printhead on your printer
we urge you to refill or replace the empty ink cartridges as soon as they run
out to prevent printing on an empty cartridge.
How to Refill an HP Ink Cartridge 123
Something you need to know Refilling your empty ink
cartridge 123 is very easy and not hard at all plus (+) it is very cost
effective rather than buying new cartridges at expensive prices
For this Procedure of refilling HP Ink Cartridge 123 you
would need the following
- Pair of plastic gloves
- Injection Needles
- Bottle/s of ink
The amount of ink and materials you need will depend on how
many cartridges you need to refill.
We will then start with the black ink cartridge of the Deskjet
2620 or HP Deskjet 2600
How to Refill HP BLACK Ink Cartridge
- Open your printer door way and Allow the cartridges to automatically stop moving.
- Gently eject your cartridge (place them down without touching the sensors of the cartridges).
- Fill up a syringe with ink from your ink refill bottle.
- Peel off the label on the cartridge.
- Put in Syringe in the bottle of ink. You can put in about 4ml of ink. If you’re refilling a high yield cartridge, you can put in about 10ml of ink.
- Insert the syringe into the hole. NOTE when doing
this you might feel some level resistance from the sponge in the cartridge.
Push the needle down gently so it goes into the sponge. Before pressing down on
the syringe for the ink to spread on the sponge. Always
keep your eye on the hole as ink might start spilling out of it if you put too
much
- Use a wipe or a tissue to clean off any ink that pops at the top and bottom of the Cartridge until the ink stops pouring heavily
- Leave the cartridge somewhere without shaking it for at least 5min – 10mins to allow the sponge to fully soak in the ink.
- Insert cartridge back into the printer. HP printers will still think your cartridge is empty. Simply bypass this message to keep printing.
Comments